bob smith industries bsi-109, relleno para espacios de curado instantáneo, 8 oz.
- Marca:
bob smith industries
- Código producto: B01140EHFI
- Disponibilidad: Traemos a pedido, tiempo de 15 a 25 dias.
-
$CLP 54.000
TÉRMINOS Y CONDICIONES
------------------------------------------
- El producto se trae a pedido, en un transcurso de 15 a 25 dias, si alguna restriccion de un ente gubernamental o de salud publica cambia o restringe vuelos, los pedidos pueden demorar mas tiempo.- Precios pueden cambiar previo aviso. Depende de precio con proveedores o existencia.
- Fotos referenciales del producto, consulte no mas
- Despachamos a todo Chile con Starken.
- Productos importados de Estados Unidos, es probable que los productos electronicos trabajen en 110V y NO en 220V, podria usar un transformador, para mas informacion primero nos puedes preguntar todas las inquietudes que tengas.
-Country Of Origin: United States
-Package Width: 5.08 Centimeters
-Package Height: 16.51 Centimeters
-Package Length: 5.08 Centimeters
Insta-cure+ is a higher viscosity ca for loose fitting joints in which the adhesive must bridge gaps. Normally, the thicker ca is applied to one surface and then the parts are held tightly together for about 5 to 15 seconds. For large surface areas, including those with close fitting joints such as laminations, insta-cure+ should also be used. To prevent premature curing, do not spread the glue into a thin film. Lay down a serpentine bead with about 1" separations on one surface, then assemble the parts, letting the pressure spread out.
-Package Width: 5.08 Centimeters
-Package Height: 16.51 Centimeters
-Package Length: 5.08 Centimeters
Insta-cure+ is a higher viscosity ca for loose fitting joints in which the adhesive must bridge gaps. Normally, the thicker ca is applied to one surface and then the parts are held tightly together for about 5 to 15 seconds. For large surface areas, including those with close fitting joints such as laminations, insta-cure+ should also be used. To prevent premature curing, do not spread the glue into a thin film. Lay down a serpentine bead with about 1" separations on one surface, then assemble the parts, letting the pressure spread out.
