autool sdt-206 probador de diagnóstico de fugas de combustible automotriz 2 modos probador de fugas de sistema de tubería de conducto de automóvil detector de fugas de combustible de automóvil para vehículo de 12 v barco con medidor de flujo ajustable det

TÉRMINOS Y CONDICIONES

------------------------------------------

- El producto se trae a pedido, en un transcurso de 15 a 25 dias, si alguna restriccion de un ente gubernamental o de salud publica cambia o restringe vuelos, los pedidos pueden demorar mas tiempo.
- Precios pueden cambiar previo aviso. Depende de precio con proveedores o existencia.
- Fotos referenciales del producto, consulte no mas
- Despachamos a todo Chile con Starken.
- Productos importados de Estados Unidos, es probable que los productos electronicos trabajen en 110V y NO en 220V, podria usar un transformador, para mas informacion primero nos puedes preguntar todas las inquietudes que tengas.

- This machine have 2 modes( AIR Mode and SMOKE mode) detect the leakage of pipe systems on cars, motorcycles, boats...such as fuel pipe, air intake system and cooling tank.
-The machine will change special oil into smoke, then blow smoke into sealed pipe system. you will find leak point in pipe via the smoke.
-This upgraded machine now can work on EVAP system (pressure of machine was larger than EVAP request )
-Inbuilt air compressor,Instant smoke generation. Self-protective system will keep machine away from overload. Combine with adjustable flowmeter and pressure guage,we can adjust output of smoke ,then check leakage level via smoke flow variety
-This machine can show Flow Gauge and Liquidometer Gauge.Input :12V DC ; Smoke output value: 6L/min,

Operation1.Open the engine cover, and hang the detector in the cover.2.Disconnect the pipe that needs to be connected with detector. If the pipe needs to be disconnected in the middle. Please secure the other side with a rubber stopple.3.Secure this side with proper taper stopple/pipe, and connect it with smoke output tube.4.Connect detector with DC12V battery: red with positive, black with negative. Do not connect in a contrary way.5.Turn on the power switch, and detector starts to work.6.Adjust the flow gauge. Control the input smoke value and pressure to make sure the pipe system can afford the pressure.7.In about 3 minutes, the pipe will be filled with smoke.8.Observe the floating ball in flow gauge. If the floating ball stays still in the bottom, the pipe is sealed with. If the floating ball is arising or bouncing, the pipe is leaking.9.Position the leak points by floating ball. If the bounce arises highly, the leakage is serious.10.Check the leak points. Please use head lamp if necessary.11.After leak detection, please connect well the wires and pipe.Do not run the detector over 5 minutes. It needs interval rest.The detector has protector. If it exceeds working limit, it will power off automatically. In this condition, please operate it later.MaintenanceWith longtime high temperature, the smoke and oil will oxidize and deteriorate. It will infect the service life of smoke generated part, so please change smoke and oil regularly.1.Before filling new oil, please pour out the remaining oil in the detector.2.When the smoke output has water drops, please replace with new oil.3.Liquid paraffin and baby oil are OK. Please fill new oil with equipped oil bott